Table of Contents
Advertisement
Step 4 In the IPsec Support section of the tab, click Enable. Set NAT Mode to Bypass if it is not already selected. Click
Save.
Figure 57 Enable IPsec, set NAT mode to Bypass, and Save
Step 5 In the Tunnel Configuration section of the same tab, enter IPsec tunnel configuration information for the first
tunnel, as shown in the following figure. When you have finished entering information for all the fields, click
Add/Update to save the tunnel configuration.
Figure 58 Security — IPsec tab Tunnel Configuration settings completed for first example
| Page 93
Vanguard 3000 Series Multicarrier Cellular Data Modem & IP Router PN 001-7300-100 Rev. B
Advertisement
Table of Contents
