CalAmp Vanguard 3000 User Manual page 13

Table 5 External connectors
Panel Indicators Connection
COM RS-232
ANT SMA
AUX (Figure 6) SMA
AUX (Figure 7) RP-SMA
GPS SMA
DIV SMA
LAN 1, LAN 2 RJ-45
SIM/SVC USB Mini
RESET
PWR Jack Molex 43025-0400 receptacle for
four-pin power plug with optional
ignition sense
SIM/SVC SIM Card socket
Table 6 Status LEDs
Function Off
RSSI
SVC
NET No
connectivity
GPS Disabled
AUX Disabled
• If SVC is solid, then the modem is connected to the Internet. If it is flashing, the modem is trying to connect to the
network.
• AUX refers to WiFi in mobile models.
The LEDs behavior is different than the table at boot. The boot sequence is: all red, all amber, all green, all flash green
three times, and then the boot sequence is complete.
Green Flash Green
Strong
3G 3G/NC
Rx data
Fix Search
Good
Vanguard 3000 Series Multicarrier Cellular Data Modem & IP Router PN 001-7300-100 Rev. B
Description
Serial to IP conversion use
Primary RF Antenna
Cellular Diversity antenna
WiFi antenna
GPS Antenna
Cellular Diversity Antenna
Interface for Ethernet connection to devices
Available for CalAmp Support Use Only
Hold for one second to reset unit. If held for at least 4 sec,
unit will reconfigure to factory default settings.
Bottom pins: +9-28VDC power (pin 1) and ground (pin 2)
Top pins: optional ignition-sense (3) and not connected (4).
See diagram for compatible cable on the following page.
Interface for SIM card. Your wireless service provider will
supply the SIM card with your wireless service contract.
Red Flash Red
Weak/None
NC
Tx data
No fix
Failed
Amber Flash Amber
Medium
2G 2G/NC
Rx/Tx
| Page 7