Table of Contents
Advertisement
Hit SPACEBAR to stop autoboot in
CA-Boot>
IMPORTANT: If the CA Boot version is CAv13 or earlier and Vanguard firmware 5.1.1 or later is being installed, then
the bootloader must be upgraded with the following steps. Otherwise, skip to Upgrading the Vanguard
Application, below.
8. Type the command caf and Enter. The Vanguard will transfer two files from the PC and write them to flash.
CA-Boot> caf
EMAC:KS28873 PHY3 detected
EMAC: PHY Speed: 100BT HD
IFTP from server 192.168.1.100; our IP address is 192.168.1.50
Filename 'boot-32M.bin'
Load address: 0x20000000
Loading: ###
done
...
After writing the files, the Vanguard will reboot. Have the paper clip ready and when the "Rebooting the board..."
message appears, press and hold the reset button until the boot message appears. As before, release the paper clip
and press the spacebar to stop at the CA-Boot prompt. (Note that the CA-Boot version has changed.)
...
Copy to Flash... done
Protected 1 sectors
Done.....
Rebooting the board...
CA-Boot>
Boot 1.0-CAv3
Uncompressing image...
CA-Boot 1.1.1-CAv14
...
Hit SPACEBAR to stop autoboot in
CA-Boot>
Upgrading the Vanguard Application
Type the command call and Enter. The Vanguard transfers files to memory and to flash. The process takes
approximately 8 minutes, after which the Vanguard reboots.
CA-Boot> call
EMAC:KS28873 PHY3 detected
EMAC: PHY Speed: 100BT HD
TFPT from server 192.168.1.100; our IP address is 192.168.1.50
...
Fetching and Writing ODP image...
Rebooting...
3 seconds ...
3 seconds ...
Vanguard 3000 Series Multicarrier Cellular Data Modem & IP Router PN 001-7300-100 Rev. B
| Page 128
Advertisement
Table of Contents
