Table of Contents
Advertisement
• Source Identification
The Unit's IP address that will be included in the NMEA message payload.
SMS Notification
• Destination 1 / Destination 2 / Destination 3
Alarms and notifications can be sent to up to three SMS destination addresses. Destination addresses are typically
numeric digits only including the country code prefix. The check box in front of each destination address can be
used to enable or disable each address entered in the adjacent field. The report will consist of the Unit ID and colon
(:) if the Unit ID is not blank, and the appropriate label from the I/O Settings » Labels tab.
More information about the Vanguard 3000 — SMS Interface is provided in APPENDIX D.
Triggers – Device
• Cell Temperature and thresholds
Enable or disable NMEA alarm and notification when temperature goes out of range.
Triggers – Analog Input
• Analog Input and thresholds (1 or 2)
Enable or disable NMEA alarm and notification when an analog input goes out of range.
Triggers – Digital Input
• Digital Input 1, Digital Input 2
Enable or disable NMEA alarm and notification when the input state changes.
NMEA Message Format
Messages generated by the Vanguard 3000 I/O Agent subsystem for alarms and indications conform to NMEA 0180.
Explanation of the Protocol Data Unit (PDU) format that is used and example messages are provided in APPENDIX E.
These messages will be sent to the manager at the NMEA manager IP address and port specified in the above field.
Vanguard 3000 Series Multicarrier Cellular Data Modem & IP Router PN 001-7300-100 Rev. B
| Page 84
Advertisement
Table of Contents
