Table of Contents
Advertisement
Configuration File
The Configuration File section allows you to create backups of how your Vanguard 3000 is configured and to restore all
configuration settings from a backup file if one has been created.
CAUTION: At the time of this writing, use of Internet Explorer 7, Internet Explorer 9, and Internet Explorer 10 browsers
are not recommended for backing up or restoring the configuration file.
• File
Field to input the uploaded configuration file. The Browse button can be used to locate the file in a specific folder.
The configuration file to be uploaded must be named config.xml. If multiple files need to be maintained, it is
recommended that separate directories be used. The configuration backup or restore can be done over the local
Ethernet connection, or over the cellular network if Remote Administration is enabled, allowing remote access to
the Vanguard 3000 Web interface and the Firmware Update page. If restoring a configuration that specifies
connection on a different IP address for remote administration, you will need to know this IP address and enter it in
your browser address bar to navigate to the Vanguard Web interface after the Vanguard resets.
• Upload Button
After selecting the firmware configuration filename above, press the Upload button to begin the configuration
loading process.
• Save
Returns a link to the configuration file on the unit. Right-click the link and select "Save Target As..." to save the file.
The link page refreshes after 15 seconds. It is recommended to use the specified filename to save the file. If multiple
files need to be maintained, it is recommended to use directory paths to separate the files.
4
IP ADDRESSING
4.1
OVERVIEW
When Vanguard cellular router is connected to a cellular carrier, it will always have at least two IP addresses. The first is
the local area network (LAN) address. The Vanguard can be accessed through either the LAN 1 or LAN 2 Ethernet
connectors on the front panel using this IP address. This IP address is user configurable and is saved locally in the
Vanguard. The factory default IP address is 192.168.1.50 with a subnet mask of 255.255.255.0.
The second Vanguard IP address is assigned by the cellular carrier each time the Vanguard connects to the cellular
network. Often, this IP address is publicly accessible from the Internet, however in some instances the cellular carrier
may assign an IP address that is protected by firewalls. When a publicly accessible IP address is assigned, data flows can
be initiated from either the Vanguard or from the Internet. When an IP address is protected by cellular firewalls, data
flows can only be initiated from the Vanguard. In either case, after a data flow has been established, data is free to
move in both directions.
For mobile models equipped with WiFi, the Vanguard will be assigned a third IP address on the WiFi wireless network.
Vanguard 3000 Series Multicarrier Cellular Data Modem & IP Router PN 001-7300-100 Rev. B
| Page 87
Advertisement
Table of Contents
