Table of Contents
Advertisement
Upgrades
Firmware Upgrade Notes
v5.1.0 to
Web pages must be updated to
v5.1.0B1
point to correct server, and
NTP must be enabled. This
firmware upgrade can be
performed successfully if it is
scheduled immediately and is
not interrupted.
v5.1.0B to
The file is downloaded, but the
v5.1.1
upgrade script stops before
installation begins. When the
unit reboots, DeviceOutlook
thinks the upgrade completed
successfully, but likely has not.
v5.1.1 to
This firmware upgrade can be
v5.1.2
performed successfully if it is
scheduled immediately and is
not interrupted.
v5.1.2 and
Upgrades can now be
up
scheduled as future upgrades
become available, and the
Vanguard will reschedule if
reset. Take precautions to plan
for updates and ensure the
Vanguard power is not
interrupted during updates.
TO PERFORM FIRMWARE UPGRADES
Requirements
The upgrade procedure requires the following:
• PC or notebook computer with a browser and available Ethernet LAN port.
• Power supply in the range of 9-28 V DC, 15-45 W (the standard power cable for mobile model Vanguard routers is
equipped with a fuse holder and 2A fast-acting fuse, EF2AL250VP, recommended).
• Ethernet cable.
• Vanguard 3000 firmware upgrade package (appropriate file from the above list).
• Vanguard 3000 router currently running firmware that is at the release version immediately before the version that
the upgrade is for.
Configuration Upgrade Notes
In this firmware version, there
was no configuration upgrade
support for the Vanguard 3000
client.
This can be performed
successfully if it is scheduled
immediately and the
configuration file is hand-
crafted to anticipate
differences in the layout. Table
entries can corrupt the
parameter file. SNMP and GPS
IP addresses are handled
incorrectly.
Same as above.
Configuration upgrades can be
scheduled successfully in the
future. DeviceOutlook 1.6.1
only exposes "safe"
parameters that can be easily
corrected. SNMP and GPS IP
addresses are handled
correctly.
Vanguard 3000 Series Multicarrier Cellular Data Modem & IP Router PN 001-7300-100 Rev. B
Notes
In these firmware versions, the
Vanguard did not acquire the
time from the GPS module. To
be set to the correct time, the
unit must be set up to connect
to and acquire current time
from an NTP server. In these
and the following firmware
version, the default
DeviceOutlook (then, COLT)
were set as:
coltota.calamp.com:20500
coltota.calamp.com:20511.
Both servers should now be
specified as:
ota.calamp-ts.com: 20511,
but upgrading does not
automatically update the
existing settings.
See above.
DeviceOutlook replaces the
former device and network
management components,
CalAmp Enterprise Services
(CES), of the CalAmp On-Line
Telemetry (COLT) system
platform.
| Page 123
Advertisement
Table of Contents
