Power Over Ethernet Cli Commands - Avaya C360 Installation And Configuration Manual

Power over Ethernet CLI Commands

In order to...
Perform a hardware reset of
the switch and the PoE circuitry
Perform a hardware reset of
the entire stack and the PoE
circuitry
Enable the load detection
process and power delivery for
the port
Disable the load detection
process and power delivery for
the port
Configure the priority level of
powering the port.
Set the type of powered device
connected to the PoE port.
Configure PoE traps and the
consumption usage threshold
value.
Show the current status of the
PD inline power on all ports
Use the following command...
reset module-and-powerinline
reset stack-and-powerinline
set port powerinline enable
set port powerinline disable
set port powerinline priority
set port powerinline type
set powerinline trap
show powerinline
Power Over Ethernet
Issue 1 July 2006 191