• Avaya Warranty and License Agreement Avaya P130 Documentation and Utilities CD The CD contains the latest Technical Documentation for the Avaya P130 Workgroup switches and files for use with the Embedded Web Manager. Technical Documentation You can view and print the Technical Documentation using Adobe® Acrobat® Reader.
Rack mount (optional) WARNING: Disconnect all cables from the unit before proceeding with the rack installation. Snap open the hinged ends of the unit’s front panel to reveal the screw holes. Closed hinged end P133G2 Avaya 11 12 OPR PWR CONSOLE...
Power up Avaya P130 AC Version Insert the power cord into the power connector (BUPS or Power Supply) on the rear of the unit. BUPS connector AC connector Insert the other end of the power cord into the electricity supply or the BUPS connector.
PWR – Shows power ON/OFF or BUPS used Basic configuration To connect a PC terminal or VT-100 terminal to the Avaya P130 If you are using a PC, initiate a VT-100 terminal emulation session using an application such as Windows® HyperTerminal.
Setting the Parameters If you wish to change the default parameters shown and configure the mandatory parameters, we recommend that you use the Command Line Interface (CLI). For further information, please refer to Chapter 6 of the Avaya P130 Documentation.
Page 7
Default Switch Parameters Configuration Parameter Default Setting P130 IP address 149.49.32.134 Default gateway 0.0.0.0 VLANs VLAN 1 Spanning tree Enabled Bridge priority for Spanning Tree 32768 NTP server IP address 0.0.0.0 Timezone offset 0 hours Read-only SNMP community string Public Read-write SNMP community string Public Trap SNMP community string...
Run the Web-Based Manager (optional) To configure the Avaya P130 you can use the P130 Web-based Manager in addition to using the CLI. System Requirements Minimum hardware and Operating System requirements are: • Windows® 95 or NT® 4.0 or higher •...
Page 9
• Either install the plug-in from the CD as follows: 1. Close all unnecessary applications on your PC. 2.Insert the “Avaya P130 Documentation and Utilities” CD in the CD drive. 3.Click Start on the Task bar. 4.Select Run. 5.Type x:\emweb-aux-files\plugin_1_2_2.exe (where x: is the CD drive letter) 6.Follow the on-screen instructions.