Lamp Menu - Christie M Series User Manual

M series
Hide thumbs Also See for M Series:
Table of Contents

Advertisement

• INPUT LEVEL DETECTOR
The Input Level Detector check box enables specific thresholds for blacks and whites. Input levels that fall
below a specified level value (see below) are displayed as black, and all others are displayed as white. To use:
1. Enable Input Level Detector and display a continuous greyscale.
2. Set Level Detector Threshold to near black (such as 200).
3. Adjust Offsets to minimize area of black stripe.
4. Set Level Detector Threshold to near white (such as 800).
5. Adjust Gains to minimize area of white stripe.
• LEVEL DETECTOR THRESHOLD
Input Level Value defines the value to be used by the Input Level Detector in recognizing blacks and whites.
See Input Level Detector, above.
• ASPECT RATIO OVERLAY
Check this box to display an overlay pattern over the image. The overlay shows the boxes corresponding to the
size and shape of different aspect ratios.
• TEST PATTERN COLOR SWAP
This function swaps the green and red color when drawing the Grid test pattern, and may be helpful when
adjusting convergence on the projector.
• CALIBRATE LITELOC
The LiteLoc calibration process must be run to calibrate the LiteLoc sensor on all model types. "Constant
Intensity" mode cannot operate correctly if the calibration has not been performed. The calibration must be
done in Dual Lamp mode, after the lamps have warmed up for at least 5 minutes.
for the duration of the calibration, and will automatically open again when the calibration is complete.
OPTION CARD SETTINGS - S
Allows adjustment of any settings specific to each option card that is currently installed in the projector.
DYNAMIC IRIS - S
Refer to Image Settings>Advanced Image Settings
3.9

Lamp Menu

LAMP OPERATION
Select the operational mode to be assigned to the
lamp(s) from the Lamp Operation drop-down list. If
a lamp fails to strike on the first attempt, you can
attempt upto 3 more strikes.
M Series User Manual
020-100009-05 Rev. 1 (09-2010)
UBMENU
UBMENU
Section 3: Operation
The shutter will close
NOTE:
F
3-39 L
M
IGURE
AMP
ENU
3-51

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents