Christie M Series User Manual page 118

Section 4: Web User Interface
To Add a GPIO Event
1. Click Add to open the RTE Wizard.
2. Select the GPIO Event tab.
3. For the GPIO Event option define the Input
Condition field as required. The Input
Condition field contains 7 blocks which refer to
the 7 I/O pins on the GPIO connector. Pin 1 =
+12V and Pin 5 = Ground are not included or
changed.
2)
L, and X as shown in
See Appendix B:
To Add a Function Key Event
1. Click Add to open the RTE Wizard.
2. Select the Function Key Event tab.
3. Select a Function key from the drop-down list as
shown in Figure 4-20 Function Key
to Section 3: Operation
To Add a DMX Channel Event
1. Click Add to open the RTE Wizard.
2. Select the DMX Channel Event tab.
3. Select a DMX channel (DMX-56 to DMX-61)
from the drop-down list as shown in Figure.
Refer to Section 3: Operation
information.
4-12
Clicking a block toggles between H,
Figure 4-19 GPIO
for detailed information.
for detailed information.
for detailed
Event.
Event. Refer
F 4-19 GPIO E
IGURE
F 4-20 F
IGURE UNCTION
F 4-21 DMX C
IGURE HANNEL
VENT
K E
EY VENT
E
VENT
M Series User Manual
020-100009-05 Rev. 1 09-2010