Christie M Series User Manual page 62

Section 3: Operation
CHANNEL EDIT — STEP 2
To edit parameters shown in the Channel Setup menu, select the relevant channel and press E
Channel Edit menu will appear similar to the sample shown below.
CHANNEL EDIT — STEP 3
If desired, review and/or edit the following channel setups in the Channel Edit menu:
• NAME
An alphanumeric label can be defined and/or changed here. Channel names can be up to 12 characters in
length. The default name is the horizontal and vertical sync frequencies.
• CHANNEL
A two-digit channel number can be changed here.
exists, a dialog message appears indicating that this number is already in use–assign a different channel
number. You can define up to 99 channels.
2)
• SLOT
1-4, corresponding to which slot in the projector's input panel the source is connected:
• INPUT
1-6, corresponding to which input on the selected slot the source is connected to.
• IN MENU
If checked (default, except for automatically defined channels with unchanged parameters), this defined
channel will then appear in the list available when C
be accessed via C
channel list is an option that must be set in the Menu Preferences menu.
• AUTO SELECT
If checked, (default), the projector can automatically locate this channel when an incoming input signal
matches. If not checked, the projector can locate the selected channel only when it is directly selected via
C
on the keypad—and a change in input signal will not result in a channel change.
HANNEL
3-16
F
IGURE
on the keypad or via the Auto Source function.
HANNEL
3-16 C E
HANNEL DIT
If you enter a channel number that already
NOTES: 1)
key is pressed. If unchecked, the channel must
HANNEL
. The
NTER
On-screen display of the
NOTE:
M Series User Manual
020-100009-05 Rev. 1 (09-2010)