Christie M Series User Manual page 101

PIP WINDOWS OPTIONS - S
• PIP POSITION PRESETS
Choose a preset location and size of the PIP window. While in split screen mode, several channel controls that
resize image will be disabled. These controls are size, H-Position and V-Position.
• PIP WINDOW SIZE
Sets the width of the PIP window in pixels. The active portion of the input signal, as determined by blanking
controls, will be scaled to fit into the PIP window. The height of the PIP window will be set to maintain the
aspect ratio of the image being captured, as determined by the Vertical Stretch control.
• PIP H-POSITION
Sets the center position of the Picture-In-Picture window on the screen.
• PIP V-POSITION
Sets the center position of the Picture-In-Picture window on the screen.
• PIP BORDER WIDTH
Specify how thick the Picture-In-Picture border should be. Setting the control to zero disables the border.
The thickness of the border is proportional to the size of the PIP image. Larger windows will have
NOTE:
larger borders.
• PIP BORDER COLOR
Choose the color of the optional border around the Picture-In-Picture image.
setting the width to zero.
PIP SIZE & POSITION - S
Most controls in the PIP Size and Position menu adjust the PIP (secondary) image in the same fashion as their
counterparts in the main Size and Position menu.
• POSITION PRESETS
Set the location of the PIP (secondary) image in the display.
PIP IMAGE SETTINGS - S
The controls adjust the PIP (secondary) image in the same fashion as their counter parts in the main Image
Settings menu.
FADE TIME
Sets the amount of time (in seconds) it takes to fade between images on a source switch and fades in the PIP
image.
FRAME LOCKING
When the selection is set to Frame Lock, output image frames are locked to the input. When locked, the
output is always locked to the primary input, never the secondary image. Select Free Run and this will set the
output to close at 60Hz for all sources.
When switching to a new input with frame locking enabled, the image will be black for the short period while
the system locks onto the new input.
M Series User Manual
020-100009-05 Rev. 1 (09-2010)
UBMENU
UBMENU
UBMENU
Refer to 3.7 Image Settings Menu
NOTE:
for details of Contrast to Advanced Image Settings.
Seamless switching is only available when free run is selected.
NOTE:
Section 3: Operation
Disabled the boarder by
NOTE:
3-55