Christie M Series User Manual page 79

• HDMI OUTPUT LOOP SOURCE
This control is used to configure the HDMI output options. Selecting Direct Loop will directly pass-through
the HDMI input signals: on the same Twin HDMI Input Card, the Input1 signal is looped to Output1 and the
Input2 signal is looped to Output2. Selecting Main/PIP Loop will loop the Main & PIP video to the outputs,
regardless from which card these signals originate. The Main video signal is looped to Output1 and the PIP
video signal is looped to Output2. Selecting Disable will shut off the HDMI outputs completely.
LENS SETTINGS - S
• INTELLIGENT LENS SYSTEM
Check this box to enable the Intelligent Lens System (ILS). When enabled, the lens position (horizontal,
vertical, focus, and zoom offsets) are stored per channel. If you change channels, the lens position will change
as the new signal is being displayed.When ILS is not enabled, the lens is controlled independently of channels
or input signals.
• MANUAL ZOOM/FOCUS When this control is selected, the holding current is removed from the zoom
and focus motors so that they can be changed manually.
manually when this control is not selected, as this will result in damage to the motors.
• CALIBRATE
The lens calibration procedure is needed each time a new lens is installed in order for the ILS feature to
perform reliably. This procedure calibrates; horizontal, vertical, focus, and zoom offset movements.
• LOCK ALL LENS MOTORS
Select this check box to prevent all lens motors from moving. It will disable the Zoom, Focus, Horizontal and
Vertical Position settings, effectively locking out any changes and overriding all other lens features. This
feature is particularly useful to prevent accidental lens position changes in multi-projector installations.
• CALIBRATE ON NEW LENS
Check this box to prompt for a lens calibration each time a lens is inserted. The user will always be prompted
before starting the calibration.
• CALIBRATE ON STARTUP
Check this box to initiate a 'Lens Reset' procedure on every power-up. This is useful if the lens is subject to
manual movement between power sessions.
• HOME POSITION
Return the lens to the horizontal and vertical home position. Focus and zoom are unaffected.
• CALIBRATION STATUS
Displays the current lens calibration status.
POWER MANAGEMENT - S
• LCD BACKLIGHT
The backlight for the LCD has 3 states. Always On, Always Off, or Timer. The backlight will turn on again
when any key on the LCD is pressed or if an alarm is raised.
• LCD BACKLIGHT TIMER
Set how long the LCD backlight stays on (in seconds) when in timer mode.
• LCD BACKLIGHT LEVEL
Sets the LCD backlight brightness level. Maximum 25/Minimum 0.
M Series User Manual
020-100009-05 Rev. 1 (09-2010)
UBMENU
UBMENU
Zoom and Focus should not be adjusted
NOTE:
Section 3: Operation
3-33