Christie M Series User Manual page 85

• SOFTWARE TERMINATION
This control supplies a signal to the card to switch termination resistance in/out of the circuit. It may be
necessary to clear this setting upon card removal. By default SW termination is disabled. The Input
termination (2 Watt, 120 Ohm) is required on the last DMXC card in a loop through configuration. (i.e. only on
the last projector). Termination may be either hardware (by plugging in a termination dongle, etc) or may be
switched in by software, but should not be both.
software termination is only in place when the projector has AC applied. If there are cases where the network
is required to be terminated without AC applied to the last projector, then a hardware terminator should be
used
• ARTNET UNIVERSE
For DMX512, each universe represents a separate electrical circuit (up to 512 devices/channels). For ArtNet
however, 'DMX' data is broadcasted over an Ethernet network, so every device will receive every packet of
data, whether they belong to that universe or not. This control specifies which universe the projector belongs
to, so it can filter out all other data packets. The Universe applies to ArtNet only, and does not apply to the
DMXC input card.
• ARTNET SUBNET
This is the highest level address in an ArtNet network, providing expandability beyond the universe level.
This control specifies which ArtNet subnet (group of universes) the projector belongs to. The Subnet applies to
ArtNet only, and does not apply to the DMXC input card.
• INPUT NOISE FILTER
The Input Noise Filter eliminates DMX/ArtNet input oscillation, which can occur on some DMX control
boards. This can cause fine resolution controls (e.g. Lens, Brightness) to continually change. A filter setting of
0 will turn off the filter; a setting of 1 will filter +/- 1 step changes, etc. Using this filter will decrease the fine
control precision of some slider controls. By default this filter is set to 0 (Off). It is not recommended to use
this feature unless you are experiencing problems with your DMX input.
• HOST NAME
This will be used to respond to ArtNet polling queries. "Christie" will be the short name, "Christie_HostName"
will be our long name. By default the host name is composed from the projector name and serial number.
(Default = "<unit name>_<serialno>").
tions->Ethernet Settings->Host Name.
GEOMETRY AND COLOR - S
In the Configuration menu, select the Geometry and Color submenu when you need to modify overall color
performance and/or image geometry for all sources.
• TEST PATTERN
Choose the desired internal test pattern, or select OFF to turn off a test pattern. Alternatively, use the T
for cycling through test patterns.
M Series User Manual
020-100009-05 Rev. 1 (09-2010)
Hardware termination is recommended, because
NOTE:
The Host name is also defined at Configuration->Communica-
NOTE:
UBMENU
Section 3: Operation
key
EST
3-39