Native Instruments Groove production studio Manual page 70

Sampler LFO on the software.
LFO
The LFO (Low Frequency Oscillator) is another modulation source based on waveforms with
different shapes.
LFO Controls
Type
Speed
Phase
Sync
Destination
This is where you define up to four modulation targets for the LFO:
▪ Pitch, located on Sampler Parameter page 2
▪ Cutoff, located on Sampler Parameter page 3
▪ Drive, located on Sampler Parameter page 3
▪ Pan, located on Output Parameter page 1
Here you can choose the shape of the LFO waveform. Available shapes are
Sine, Tri (Triangle), Rect (Rectangle), Saw, and Random.
Controls the speed of the LFO measured in Hz (Hertz). If you choose to
synchronize the Speed by activating Sync, it will show musical values in-
stead.
Defines the initial phase of the LFO waveform, expressed as a percentage.
This button is used to activate synchronization of the LFO to the tempo of
your Project. If enabled, the values on the
to rhythmical values ranging from 16/1 (= one modulation cycle in 16
bars) to 1/32 (one modulation in 1/32nd note).
The Sampler Parameters in Module 1
Speed parameter will change in-
MASCHINE - Manual - 70
Sound Slots