Canon iR2020 Series Service Manual page 66

Chapter 2
7) Connect the connector [1] of the supplied repeating harness B to the connector [2] on the card reader. Using the supplied binding screw (M4x6), secure the
repeating harness B clamp [4]. Disconnect the shorting connector [5].
If the shorting connector [5] is not disconnected, a malfunction or error can result. Therefore, the shorting connector must be disconnected.
MEMO:
The removed shorting connector is no longer necessary.
8) Secure the repeating harness B [1] with the wire saddle [2].
9) Remove the two blind seals [1] from the reader left cover.
2-12
[2]
F-2-40
[1]
[4]
[5]
F-2-41
[1]
F-2-42
[3]
[1]
[3]
[2]
[2]