Chapter 9
[1]
9.4.11.9 Removing the Fixing Unit Drive Motor
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Disconnect the connector [1], remove the two screws [2], and then remove
the fixing motor [3].
[2]
9.4.12 Left Door
9.4.12.1 Removing the Drum Unit
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the front cover [1].
2) Turn the developing assembly locking lever [2] clockwise to open the left
door [3].
3) Draw out the drum unit [4].
[4]
[3]
[2]
- When attaching or detaching the drum unit, open the left door fully to pre-
vent the damage to the drum unit.
- To prevent exposure of the drum, cover the drum unit with a few sheets of
paper and place it in a safe place.
9-18
[2]
[1]
[1]
F-9-98
[1]
[3]
F-9-99
[1]
F-9-100
9.4.12.2 Removing the Rear Cover
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the four screws [1], and then detach the rear cover [2].
9.4.12.3 Removing the Left Cover (Rear)
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the three screws [1], and then detach the left cover (rear).
0011-0629
[2]
[1]
9.4.12.4 Removing the Left Door
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the screw [1] securing the door support band. Remove the
connector [2] and reusable band [3], and release the duplex unit harness
from the wire saddle [4].
0010-9897
[2]
2) Open the left door until it sops and pull out the hinge shaft [1].
[1]
[2]
[1]
F-9-101
F-9-102
[1]
[3]
[4]
F-9-103
0010-9899
0011-0612
0010-9900