Fixing Film Sensor; Removing The Drum Unit; Removing The Rear Cover - Canon iR2020 Series Service Manual

2) Remove the fixing unit harness [2] from the wire saddle [1] and harness
guide.
[2] [1]
3) Remove the screw [1], and then remove the fixing paper guide [2].
[1]
4) Remove the screw [1], and then remove the right side stay [2].
[1]
5) Remove the connector [1], and then remove the sensor harness [2].
Remove the screw [3], release the hook [4], and then remove the sensor
holder [5].
[3]
[1]
[5]
6) Release the four sensor claws [1], and then remove the fixing delivery
sensor [2].
[2] [1]
F-8-82
F-8-83
[2]
F-8-84
[2]
F-8-85
[2]
[4]
F-8-86
[2]
When installing the sensor holder, place the electrode plate [1] under the
three claws.
[1]

8.4.5 Fixing Film Sensor

8.4.5.1 Removing the Drum Unit

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the front cover [1].
2) Turn the developing assembly locking lever [2] clockwise to open the left
door [3].
3) Draw out the drum unit [4].
[4]
[3]
[2]
- When attaching or detaching the drum unit, open the left door fully to pre-
vent the damage to the drum unit.
- To prevent exposure of the drum, cover the drum unit with a few sheets of
paper and place it in a safe place.

8.4.5.2 Removing the Rear Cover

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the four screws [1], and then detach the rear cover [2].
Chapter 8
[1]
[1]
F-8-87
[2]
F-8-88
[1]
F-8-89
0010-9913
0010-9918
8-19