Pbt9500-Only Features; Bluetooth Security Features - Datalogic PowerScan PD9530 Product Reference Manual

The features in this section are valid only for PBT9500 Bluetooth models.
Also reference the Setup section for instructions on
starting on page 19.
On the Bluetooth system, it is possible to set a (configurable) PIN code to
authenticate/connect Bluetooth devices, and encrypt the data.
The Bluetooth PIN code can be enabled and configured by reading the bar
codes in the following sections.
Follow these steps to set the PIN code for a scanner:
1.
2.
3. Scan the relevant bar code from
See page 306
for this feature.
Product Reference Guide

PBT9500-ONLY FEATURES

BLUETOOTH SECURITY FEATURES

If you are using a Bluetooth scanner directly connected to a host through a
Bluetooth dongle, verify that the scanner and the Bluetooth driver used by
the dongle share the same PIN code and the same security level. Otherwise
the connection cannot be established.
Enable Bluetooth Security Mode by scanning the "Enable" bar code
below.
Select a PIN code length of either 4 or 16 characters by scanning the
appropriate bar code in
the desired alphanumeric characters from the keypad in
Keypad to set the PIN code.
in "References" for more detailed information and examples
Enter/Exit Programming Mode
"Select PIN Code Length"
"Set PIN Code"
"Linking the Reader,"
on page 226.
on page 227, then scan
Appendix D,
225