9.17 Replacing the Leg Guard
1.
Loosen the two allen screws on each mounting clamp.
2.
Remove existing leg guard from clamps.
3.
Insert new leg guard into clamps.
4.
Position each mounting clamp onto the fork under the brake cable.
The leg guard should surround, but not touch, the rear
of the front tire.
5.
Adjust the leg guard to the desired position.
6.
Tighten both allen screws on each mounting clamp securely.
Part No 1171891
Rear of
Front Tire
Leg Guard
79
Invacare® Top End® Recreation Handcycles
9 SERVICE PROCEDURES
Fork
Brake Cable
Allen Screws
Mounting Clamp