Tension Spring Installation - Invacare xlt User Manual

9.6

Tension Spring Installation

This procedure applies to Excelerator and Lil' Excelerator models only.

The tension spring is NOT intended to keep the handcycle straight when pedaling but to keep the handcycle from leaning excessively to
one side or another.
Tension is applied by loosening or tightening the eye bolts. This should be done before installation of the spring.
1. Tighten eye bolts into fork assembly and front frame.
2. Using a medium flat screwdriver, hook the tension spring to the fork assembly and front frame eye bolts.
Part No 1171891
Front Frame
Eye Bolt
Tension Spring
Eye Bolt
65
Fork Assembly
Invacare® Top End® Recreation Handcycles
9 SERVICE PROCEDURES