Invacare xlt User Manual page 89

4. If necessary, the wheel stop may be adjusted to one of three positions to
sit against the front wheel. To adjust the wheel stop, perform the following
steps:
A. Remove the mounting bolt and locknut securing the wheel
stop to the wheel tray bracket.
B. Position the wheel stop in the desired mounting position.
C. Secure the wheel stop to the wheel tray bracket with the mounting
bolt and locknut.
Rear Wheel Bar Brackets
 To properly secure the handcycle, the rear wheel bar
brackets should be adjusted to sit against the rear
wheels.
1. Loosen the two screws securing the rear wheel bar bracket to the rear
wheel bar.
2. Adjust the rear wheel bar bracket in/out until they sit against the rear
wheel.
3. Secure the rear wheel bar bracket to the rear wheel bar with the two
screws.
4. Repeat steps 1-3 for the opposite side if necessary.
Rear Wheel Bar
 To properly secure the handcycle, the rear wheel bar
should be adjusted so the rear wheels sit in the rear
wheel bar brackets.
1. Remove the two mounting bolts and locknuts securing the rear wheel bar
to the wheel tray.
2. Position the rear wheel bar to one of three mounting positions on the
wheel tray.
3. Secure the rear wheel bar to the wheel tray with the two mounting bolts
and locknuts.
Part No 1171891
Receiver
Small Mounting Bolts
and Locknuts
Bracket
Wheel Stop
Wheel Stop
Mounting Position
Mounting Bolts
and Locknuts
89
Invacare® Top End® Recreation Handcycles
10 OPTIONS
Mounting
Rear
Bolts and
Wheel
Locknuts
Bar
Screws
Large Mounting
Bolts and Locknuts
Rear Wheel Bar
Wheel Tray
Wheel Tray Bracket
Bracket