Adjusting Back Angle - Invacare xlt User Manual

7 RIDING POSITION
7.5

Adjusting Back Angle

1. If installed activate parking brake.
2. Loosen, but do not remove the four rear socket screws that secure the seat frame to the handcycle frame.
 There are two socket screws on the right and left side of the handcycle.
3. Loosen, but do not remove the hex bolts and locknuts that secure the two seat angle adjustment clamps to the rear seat supports.
 There is one clamp on the right and left side of the handcycle.
4. Perform one of the following:
• Increasing Back Angle - While lifting up on the back support tubes, pull the seat upward to the desired position.
• Decreasing Back Angle - While pushing down on the back support tubes, push the seat down to the desired position.
5. Tighten the four socket screws that secure the seat frame to the handcycle frame securely.
6. Tighten the hex bolts and locknuts that secure the two seat angle adjustment clamps to the rear seat supports securely.
Seat Angle Adjustment Clamps
Invacare® Top End® Recreation Handcycles
Back Support Tube
Rear Socket Screws
Handcycle Frame
48
Part No 1171891