Invacare xlt User Manual page 40

Top end recreation handcycles
Hide thumbs Also See for xlt:
Table of Contents

Advertisement

6 OPERATION
XLT PRO Handcycles with Twenty-seven Speed Hands-on Rapid Fire Shifter/Brake System
CAUTION
DO NOT attempt to shift gears while the XLT PRO Handcycle is stationary.
DO NOT press both shifter levers down at the same time. Doing so may damage the shifter and will void the warranty.
The gears WILL NOT shift when both levers are pressed simultaneously.
DO NOT use excessive force. This may damage the shifter and void the warranty.
There are two shifters installed on the XLT PRO Handcycle. The right
handpedal shifter operates the nine gears on the lower derailleur on the
front wheel and the manual shifter operates the three chain rings on the
upper derailleur on the crank assembly.
Shifting the chain on the lower derailleur towards the centerline of the
handcycle is for climbing/accelerating (easier cranking) (lever A) and is called
a downshift. Moving the chain on the lower derailleur out or away from the
centerline of the handcycle is for speed (harder cranking) (lever B) and is
called an upshift.
To shift gears, you MUST turn the crank forward with the chain under some
tension while the handcycle is moving.
During operation, the chain should run smoothly over the chain rings. If
there are problems with the chain, discontinue use and contact your local
bike shop.
Refer to this chart and information that follows for an explanation of the
upper derailleur chain rings in combination with the lower derailleur gears:
If your pedaling cadence is too slow, shift into a lower gear.
If your pedaling cadence is too fast, shift into a higher gear.
The chain should not rub on the front of the derailleur chain guide.
Shift into a lower gear in order to facilitate easy start-up.
NEVER shift gears while stationary or while pedaling backwards.
Keep eyes on the road when changing gears.
Invacare® Top End® Recreation Handcycles
Lower derailleur
Upper derailleur chain rings
gears (right shifter)
(manual shifter or cable
1-9
10-18
19-27
Recommended
40
Use for:
driven shifter)
Smallest
Climbing Hills or
Strong Headwinds
Medium
Flats or Gradual
Rolling Terrain
Largest
Descending Hills or
Strong Tailwinds
Not Recommended
Part No 1171891

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xlt jrXlt proXlt exceleratorXlt jr li’l excelerator

Table of Contents