Replacing Camber Inserts - Invacare Excelerator Owner's Operator And Maintenance Manual

WHEELS
ADJUSTING TOE IN/TOE OUT
1. Loosen, but do not remove the socket screws and clamps that secure camber
inserts to the camber bar (DETAIL "A").
2. Slowly rotate the camber insert until the rear wheels are approximately in a straight line.
3. Securely tighten the socket screws and
clamps that secure the camber inserts
to the camber bar.
4. Measure the distance between the
center lines at the rear and front of
the rear wheels at approximately 12-
inches from the ground/floor. Refer to
DETERMINING TOE IN/TOE OUT in
this procedure of the manual.
5. Repeat STEPS 1-4 until the toe in/toe
out measurement is less than 1/2-inch
(0 ± 1/4-inch for maximum rollability).
DETAIL "A" CAMBER INSERTS
Camber
Socket Screw
Insert
FIGURE 2 - DETERMINING/ADJUSTING TOE IN/TOE OUT
REPLACING CAMBER INSERTS (FIGURE 3)
1. Loosen, but do not remove the socket screws and clamps that secure the camber
inserts to the camber bar.
2. Remove the existing camber insert from the camber bar.
3. Install the new camber insert into the camber bar.
4. Adjust the toe in/toe out of the wheelchair. Refer to DETERMINING/ADJUSTING
TOE IN/TOE OUT in this procedure of the manual.
Clamp
Camber Insert
Socket Screw
FIGURE 3 - REPLACING CAMBER INSERTS
Part No. 1056188
TOP VIEW
WHEELCHAIR
Clamp
Camber
Bar
Camber Bar
29
FRONT OF WHEELCHAIR
Toe-out
Toe-in
OF
Smaller Than Front
Larger Than Front
Excelerator™Series
SECTION 6
Frame