Excelerator Xlt/Xlt 2000 Footrest And Leg Guard Replacement - Invacare Top End Excelerator Owner's Operator And Maintenance Manual

FOOTREST
EXCELERATOR XLT/XLT 2000
FOOTREST AND LEG GUARD
REPLACEMENT (FIGURE 2)
Footrest
1. Note the position of the existing footrest.
2. Remove the hex bolt and locknut that secure the ex-
isting footrest to the fork.
3. Remove the existing footrest from the clamp on the
fork.
4. Slide the new footrest into the clamp on the fork to
the position noted in STEP 1.
5. Reinstall the hex bolt and locknut. Tighten securely.
6. Repeat STEPS 1-5 for the opposite footrest, if nec-
essary.
Leg Guard
1. Loosen the two (2) allen screws on each mount-
ing clamp.
2. Position each mounting clamp onto the fork under
the brake cable as shown in FIGURE 2.
NOTE: The leg guard should surround, but not touch
the REAR of the front tire.
3. Tighten the two (2) allen screws on each mounting
clamp securely.
Footrest Replacement
Fork
Clamp,
Hex Bolt
and
Locknut
Footrest
Leg Guard Replacement
Rear of
Front
Tire
Leg Guard
FIGURE 2 - EXCELERATOR XLT/XLT 2000 FOOTREST
AND LEG GUARD REPLACEMENT
27
PROCEDURE 11
Fork
Brake
Cable
Allen
Screws
Mounting
Clamp
F
O
O
T
R
E
S
T