Invacare xlt User Manual page 44

7 RIDING POSITION
Excelerator Series
Adjusting Footrest Height
 The range of the footrest is 0 to 4-1/2 inches.
Footrest height should be adjusted so that when the
user is seated with feet in the footrests, there is a 90°
bend at the knee. If this cannot be achieved by adjusting
the footrest height, adjust the seat position. Refer to
Adjusting the Seat on page 46.
1. Loosen the socket screws on each footrest bracket.
2. Slide the footplate up or down to the desired height. Allow at least 2
inches of groun d clearance.
3. Tighten the two socket screws that secure each footrest bracket.
Adjusting Footrest Angle
1. Loosen the button screws and locknuts that secure the half clamps
to the footrest weldment.
 The footplate clamps are located under the footplates.
2. Position footplates to an appropriate angle for the user.
3. Tighten the button screws and locknuts that secure the half clamps
to the footrest weldment.
Adjusting Footrest Depth
1. Remove the button screws and locknuts that secure the footplates
to the half clamps.
2. Adjust the footplates to one of five depths.
3. Line up the mounting holes in the footplates with the mounting
holes in the footplate clamp.s
4. Install the button screws into the mounting holes and tighten
securely with the locknuts.
Invacare® Top End® Recreation Handcycles
Excelerator Series
Height
Adjustment
Angle
Adjustment
Depth
Adjustment
44
Socket Screws
Footplate
Footplate
Button Screw
Footplate Button Screw
Locknut
Part No 1171891
Footrest
Bracket
Locknut