Advertisement
g. Cut the cable ties securing the backrest clamps on the side rails
on the frame and move them to a desired location.
h. Using hardware from [SHEET #3], insert the M6 x 65mm screw
through M6 flat washer, backrest clamp, backrest tube, plastic
coved spacer, M6 flat washer, and the locknut respectively.
Finger tighten hardware.
i. Repeat these steps for the other side of backrest.
ii. Tighten clamp hardware using the 10mm wrench and
5mm Allen key from [SHEET #1]
1. NOTE: Do not tighten one side all the way until
backrest has been attached to both sides of
frame with hardware finger tightened
iii. Its likely additional adjustments will be needed. For
now, estimate a good starting location.
i.
7. Bumper Installation
a. Remove packaging materials from camber tube at rear of frame
assembly.
b. Slide the bumper clamp with flag holder onto the bumper
receiver on the rider's left-hand side
c. Slide the bumper clamp without the flag holder onto the
bumper receiver on the rider's right-hand side
d. Slide the bumper through the clamps into the bumper
receivers.
Part No 60121632 Rev A
e. Once the bumper has bottomed out against the camber tube,
tighten the bumper clamp using the 4mm Allen Key and the
bumper clamp with safety flag mount using the 5mm Allen Key
from [SHEET #1] ensuring that the flag holder remains vertical.
(Recommended torque: 8-9 N.m.)
8. Tire Inflation
a. Remove the valve stem cap
b. Loosen up needle to outward position
c. Thread on valve stem adapter
d. Inflate tires using a standard Schrader air nozzle with a Presta
valve adapter or a Presta valve nozzle (do not exceed
recommendations embossed on tire). We recommend
approximately 80 psi and then fill to preference)
9. Final Safety Check
a. Refer to user manual for all associated risks before using a
handcycle.
b. Verify tire inflation
c. Double check that all fasteners are secure
d. Verify braking functions
e. Install safety flag
f.
Ensure footrests are adjusted and secured
10. Rock and Roll!
8
f.
Instructions, Force G Customer Assembly
Advertisement
