Section 7 - Service Procedures; Fork Assembly Installation; Tension Spring Installation - Invacare Excelerator Owner's Operator And Maintenance Manual

SECTION 7
Section 7 - Service Procedures - includes the following:

Fork Assembly Installation

Tension Spring Installation

Seven (7) Speed Shifter Cable Installation
Seven (7) Speed Shifter Adjustment/Replacement
Seven (7) Speed Hub Chain Installation
Chain Adjustment
Parking Brake Adjustment/Replacement
Seat Upholstery Replacement
Back Upholstery Replacement
After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage
may result.
FORK ASSEMBLY INSTALLATION (FIGURE 1)
1. Remove the fork assembly from the packaged container.
2. Install washer and ball bearing housing onto fork assembly.
3. Slide fork assembly through the opening in the front frame (Goose Neck).
4. Install ball bearings on fork assembly.
5. Place locknut over fork assembly and
tighten.
6. Tighten locknut setscrews.
TENSION SPRING
INSTALLATION (FIGURE 1)
NOTE: The tension spring is NOT intended to
keep the handcycle straight when pedaling but
to keep the handcycle from leaning excessively
to one side or another.
1. Tighten eye bolts into fork assembly
and front frame.
NOTE: Tension is applied by loosening or
tightening the eye bolts. This should be done
before installation of the tension spring.
2. Using a medium flat screwdriver, hook the tension spring to the fork assembly and
front frame eye bolts.
Excelerator™Series
WARNING
Locknut
Eye Bolt
Front
Frame
Tension
Spring
Eye Bolt
Adjustable Chain Idler
FIGURE 1 - FORK ASSEMBLY/
TENSION SPRING INSTALLATION
30
SERVICE PROCEDURES
Set Screw
Ball Bearings
Goose Neck
Front Frame
Opening
Ball Bearing
Housing
Washer
Fork
Assembly
Part No. 1056188