Removing A Sas Controller Daughter Card - Dell POWEREDGE R805 Hardware Owner's Manual

Figure 3-11. SAS Controller Daughter Card Cabling
1
1 SAS controller daughter card
3 SAS_A connector (below BKPLN
connector)
6 For battery-cached SAS RAID controllers, install the RAID battery. See
"Installing a RAID Battery" on page 87.

Removing a SAS Controller Daughter Card

1 Disconnect the SAS cable from the SAS controller daughter card.
2 Press down on the blue release tab and push the SAS controller daughter
card out of the sideplane connector. See Figure 3-10.
3 Remove the card tray from the chassis hooks and lift the card from the
system.
4 If applicable, remove the RAID battery from the battery holder.
86
Installing System Components
2
2 SAS 0 connector
4 SAS cable (1)
3
4