Set Current Configuration As Home State - Comtech EF Data Vipersat 564L User Manual

V i p e r s a t C o nf i g u r a t i o n
Figure 3-55
Home State Configuration screen
A CDD-56X's Home State settings are typically selected so that it goes to a
configuration which is optimum for its function in the network. These parame-
ters are configured on an individual, per demod basis.
Note that each of these Receive parameters are the same as found in the Rx
Configuration screen that is in the Satellite Demod Configuration menu.

Set Current Configuration as Home State

This command sets the selected Demod's current configuration as its Home
State settings. Assuming the Demod has been properly configured using the
Satellite Demodulator Configuration menu (Rx parameters) and the Feature
Configuration menu (Vipersat STDMA setting), these parameter values will be
copied into the Home State configuration. Rather than entering each of these
values individually, this command can be used as a shortcut for establishing the
Home State settings.
Enter W at the command prompt in the Home State Configuration screen to
execute this command. Once saved, the modem will be configured with the
Home State settings at boot time and when manually reset with the Force
Modem to Home State command.
Tip: This command is useful when a CDD-56X's initial set up is completed and
the unit is functioning as desired in a network.
V i p e r s a t C D D - 5 6 X S e r i e s U s e r G u i d e
3-44