View Remote(S); Remove Timeout; Figure 3-31 View Remote(S) Screen - Comtech EF Data Vipersat 564L User Manual

V i p e r s a t C o n f i g u r a t io n
Figure 3-30
Enable/Disable Remote prompt
Enter the number of the Remote at the command prompt to toggle the Remote
from its current Enable/Disable configuration.
In the example screen shown above, both Remotes 1 and 2 are Enabled.

View Remote(s)

Entering V at the command prompt shown in figure 3-20 will display the listing
of Remote(s) that belong to the STDMA group for this Hub burst controller, and
their status, as shown in figure 3-31.
Figure 3-31
View Remote(s) screen
The display is for information only and pressing any key will return the screen
to the menu shown in figure 3-20.

Remove Timeout

Entering R at the command prompt shown in figure 3-20 will display the
Remove Timeout dialog shown in figure 3-32. Note that this menu item shows
the current setting (in seconds) for this parameter.
C h ap t e r U s i n g t h e C o m m a n d L in e I n t e r f a c e ( C L I )
3 - 3-25