Delete Remote; Enable/Disable Remote; Figure 3-27 Global Scpc Data Rate Prompt; Figure 3-28 Global Switch Type Prompt - Comtech EF Data Vipersat 564L User Manual

V i p e r s a t C o nf i g u r a t i o n
Figure 3-27
Global SCPC Data Rate prompt
Similarly, the Global Switch Type command can be used to set the switch type
for all or a majority of the Remotes. Enter H at the command prompt.
Figure 3-28
Global Switch Type prompt

Delete Remote

Entering D at the command prompt shown in figure 3-20 brings up the Delete
Remote dialog shown in figure 3-29.
Figure 3-29
Delete Remote prompt
Enter the number of the Remote CDD-56X at the command prompt to delete it
from the STDMA group for this Hub burst controller.

Enable/Disable Remote

Enter E at the command prompt in figure 3-20 to display the dialog shown in
figure 3-30. The Remotes in the network are displayed, indicating whether each
is currently Enabled (E) or Disabled.
V i p e r s a t C D D - 5 6 X S e r i e s U s e r G u i d e
3-24