Comtech EF Data Vipersat 564L User Manual page 36

I n i t i a l C o n f i gu r a t i o n
7.
8.
9.
This completes the initial configuration of a CDD-56X from the factory default
settings to a functioning, Vipersat-enabled unit. Additional configuration
parameters must be set depending on the network requirements for a specific
application.
Refer to Chapter 3, "Using the Command Line Interface (CLI)", for additional
details on configuring the target Vipersat CDD-56X.
2-12
Enter I at the command prompt to set the Managing IP Address.
The Managing IP Address is the IP address of the VMS server.
Enter H to go to the Home State Configuration menu screen, then enter
W to set the current configuration as the Home State.
Save the settings to flash by entering S at the command prompt.
V i p e r s a t C D D - 5 6 X S e r i e s U s e r G u i d e