Enable/Disable Remote; View Remote(S); Figure 3-28 Delete Remote Prompt; Figure 3-30 View Remote(S) Screen - Comtech EF Data Vipersat CDD-562L User Manual

V i p e r s a t C o nf i g u r a t i o n
Figure 3-28
Delete Remote prompt
Enter the number of the Remote CDD-56X at the command prompt to delete it
from the STDMA group for this Hub burst controller.

Enable/Disable Remote

Enter E at the command prompt in figure 3-19 to display the dialog shown in
figure 3-29. The Remotes in the network are displayed, indicating whether each
is currently Enabled (E) or Disabled.
Figure 3-29
Enable/Disable Remote prompt
Enter the number of the Remote at the command prompt to toggle the Remote
from its current Enable/Disable configuration.
In the example screen shown above, both Remotes 1 and 2 are Enabled.

View Remote(s)

Entering V at the command prompt shown in figure 3-19 will display the listing
of Remote(s) that belong to the STDMA group for this Hub burst controller, and
their status, as shown in figure 3-30.
Figure 3-30
View Remote(s) screen
V i p e r s a t C D D - 5 6 X S e r i e s U s e r G u i d e
3-24