Configuring Ipv6 Lan Connections - Cisco RV215W Administration Manual

Configuring Networking
Configuring IPv6
STEP 4
STEP 1
STEP 2
Cisco RV215W Wireless-N VPN Firewall Administration Guide
Click Save.

Configuring IPv6 LAN Connections

In the IPv6 mode, the LAN DHCP server is enabled by default (similar to the IPv4
mode). The DHCPv6 server assigns IPv6 addresses from configured address
pools that use the IPv6 prefix length assigned to the LAN.
To configure IPv6 LAN settings on your device, you must first set the IP mode to
one of the following modes:
• LAN:IPv6, WAN:IPv4
• LAN:IPv6, WAN:IPv6
• LAN:IPv4+IPv6, WAN:IPv4
• LAN:IPv4+IPv6, WAN:IPv4+IPv6
See Configuring the IP Mode
To configure IPv6 LAN settings:
Choose Networking > IPv6 > IPv6 LAN Configuration.
Enter the following information to configure the IPv6 LAN address:
IPv6 Address
for more information on how to set the IP mode.
Enter the IPv6 address of the device.
The default IPv6 address for the gateway is fec0::1
(or FEC0:0000:0000:0000:0000:0000:0000:0001).
You can change this 128-bit IPv6 address based on
your network requirements.
6
57