Allow Traffic From Inside To Outside - Cisco Firepower 1100 Started Manual

Firepower Threat Defense Deployment with FMC
• Translated Source—Choose Destination Interface IP.
Step 7
Click Save to add the rule.
The rule is saved to the Rules table.
Step 8 Click Save on the NAT page to save your changes.

Allow Traffic from Inside to Outside

If you created a basic Block all traffic access control policy when you registered the FTD with the FMC,
then you need to add rules to the policy to allow traffic through the device. The following procedure adds a
rule to allow traffic from the inside zone to the outside zone. If you have other zones, be sure to add rules
allowing traffic to the appropriate networks.
See the
Procedure
Step 1 Choose Policy > Access Policy > Access Policy, and click the Edit ( ) for the access control policy assigned
to the FTD.
Step 2 Click Add Rule, and set the following parameters:
You cannot use the system-defined any-ipv4 object, because Auto NAT rules add NAT as part
Note
of the object definition, and you cannot edit system-defined objects.
FMC configuration guide to configure more advanced security settings and rules.
Cisco Firepower 1100 Getting Started Guide
Allow Traffic from Inside to Outside
109