Debug Port-Security - Cisco Catalyst 3120 Command Reference Manual

debug port-security

debug port-security
Use the debug port-security privileged EXEC command to enable debugging of the allocation and
states of the port security subsystem. Use the no form of this command to disable debugging.
Syntax Description
This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(40)EX
Usage Guidelines
The undebug port-security command is the same as the no debug port-security command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
show port-security
Cisco Catalyst Blade Switch 3120 for HP Command Reference
B-68
debug port-security
no debug port-security
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Displays port-security settings for an interface or for the switch.
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
OL-12248-01