The Insert Matrix Tab; Naming Devices - Solid State Logic Matrix 2 Owner's Manual

The Insert Matrix Tab

The Insert Matrix tab of is the fourth tab in the Matrix Remote. This allows you to route external signal processing to your
channel insert points.
See Chapter 1 for details of connecting up your external signal processing to the Insert Matrix sends and returns.
Note that the Insert Matrix only routes Devices within the channel insert points, and is isolated from the bus insert points.

Naming Devices

The Devices column on the right-hand side of the
labelling, Insert 1 to Insert
insert number and pressing
Name pop-up appears and press OK.
The Device number which preceed the name refers to the DEVICE SEND and RTN input and output to which the Device is
connected.
Note that Matrix allows you to name different Devices with exactly the same name, in which case the Devices can be
distinguished using the Device number.
Note also that if you attempt to save a blank Device name, the Remote will return the Device to its default name,
n' where 'n' is the Device number.
Insert Matrix
16. You can rename the Devices inside the Remote by right-clicking (Mac: ctrl+click) on the Device's
Rename in the drop-down which appears. Type the name you wish to give that unit in the
Chapter 4 - Matrix Remote
tab lists the 16 devices available to you, with the default
Matrix 2 Owner's Manual
New
'Insert
67