Backing Up A Profile; Restoring A Profile; Disable Handshake; Selecting The Transport Master - Solid State Logic Matrix 2 Owner's Manual

Chapter 6 - DAW and CC Configuration

Backing Up a Profile

To back up a Profile or export it for use in another Matrix Remote, press
up, select the Profile which you wish to back up, and press Backup. In the pop-up which appears, edit the name and destination
of the file if necessary, and press Save. Your Profile will be exported as a .zip file.

Restoring a Profile

To restore a Profile from back-up or import a Profile created in another Matrix Remote, press
Profile Editor pop-up and press Restore. In the pop-up which appears, locate the Profile .zip file you wish to restore and press
Open. The restored Profile will appear in the Profile list. If the Profile name already exists the restored filename will be appended
with numeral to distinguish it from any parent Profile of the same name. You can now rename the Profile as described above.

Disable Handshake

The Disable Handshake
multiple MCU layers in use, and where these layers include both Logic and other MCU programs. Checking this box stops MCU
programs from handshaking with each other via Matrix, preventing Logic from scanning for external controllers and subsequently
creating ghost controllers of any other MCU programs.
Note: The console must be restarted if the
take effect

Selecting the Transport Master

Normally Matrix will output transport commands to whichever DAW is assigned to the currently selected layer. However, if you
are controlling more than one DAW, there may occasions when the Transport controls need to be locked to a specific DAW
which is acting as the master timeline for any other DAWs being controlled.
This is done by selecting the layer containing the master DAW within the
Master area of the Remote's
active as soon as it has been selected and will always receive commands generated
by the five primary Transport keys, the ten soft keys located directly above the main
Transport keys and the Navigation wheel and mode switch.
If None is selected within the
selected layer.
Note that a DAW Transport master is not required when controlling multiple DAWs that are connected as 'ReWire' slaves
to the Master DAW.
Matrix 2 Owner's Manual
98
box below the Edit Profiles
Disable Handshake
DAW tab. The selected transport master becomes
Transport Master, Matrix will output the transport controls to the DAW on the currently
Edit Profile
button in MCU layers will only be of use in systems where there are
status is changed for a Profile before the change will
Transport
to bring up the Profile Editor
Edit Profile to bring up the
pop-