Recalling A Tr Snapshot - Solid State Logic Matrix 2 Owner's Manual

Recalling a TR Snapshot

Enabling Total Recall
In order to recall a snapshot of the desk's settings, Total Recall must be Enabled. This is done by pressing the
located at the top of the button list in the right of the tab, or by pressing
The current status of the Total Recall is shown above the
Enabled sign. In addition, the
enabled (as shown below).
The console also provides indication that TR is enabled via the red and green
for any channel with no changes required, both lights will be on. For any channels which contain settings which do not correspond
with the selected snapshot, the green light will be on and the red light will flash.
Note that AUTO
Once TR has been enabled, the
Important Note:
performed during normal operation. Additionally, due to the quantity of information which has to be detected, the processing
speed and sound quality of Matrix is significantly reduced when Total Recall is enabled. It is therefore important to disable
Total Recall when you have finished resetting a snapshot.
Selecting a TR Snapshot
There are three groups of settings within a TR Snapshot, listed on Page 56: Group 1 consists of switches and faders which can
be reset automatically. Group 2 consists of switches which require manual resetting. Group 3 consists of pots which require
manual resetting.
To select a TR snapshot, press the
from the snapshot list in the centre of the
indicate whether or not they correspond to the selected snapshot: LEDs are unlit to indicate where the snapshot and console
match, and lit to indicate where the they do not. If all you want to do is recall a specific selection of settings without setting the
snapshot to the whole desk or even a whole channel, this can now be done manually as described below.
Note that selecting a snapshot does not change any settings until a TR snapshot is 'set' (see next page). In the instance of
a selective reset, those settings which would normally be reset automatically by 'setting' a snapshot (Group 1) can also be
reset manually. In this case Group 1 controls function exactly as if they were part of Group 2. The exception to this is the
faders which have no TR indication.
TR box in the bottom right-hand corner of the Remote window goes red to indicate when TR is
lights are also used for automation. See Pages 45 and 78 for details.
Display TR button becomes the
When Total Recall is enabled, a number of LEDs on Matrix perform a different function from that
Display TR
Total Recall
Display TR button, by either a green
Disable TR
button to enable Total Recall, highlight the snapshot which you want to recall
window, and press
Chapter 4 - Matrix Remote
in the soft key menu (See Page 44).
Enable TR
TR Disabled
AUTO lights at the bottom of the channel meters:
button.
Select TR Snap. The console LEDs will now
Matrix 2 Owner's Manual
Display TR button
sign or a red TR
61