Solid State Logic Matrix 2 Owner's Manual page 45

Digital I/O
MIX
Matrix has one stereo digital output which feeds both AES/EBU and S/PDIF connections on the desk's rear
panel. This output is controlled by the
MIX bus master. If a digital input is connected, then Matrix will lock its internal clock to it. The LED in the top
right corner of the
incoming signal.
16
The digital output can be sourced from the
LEFT
button cycles through these options, and LEDs to the right of the button indicate which source is selected. If there is an incoming
digital signal, the output will replicate its sample rate. If no digital input is detected the output sample rate will default to 48kHz –
it is recommended that an external reference is always connected to ensure that Matrix's digital I/O remains synchronised to the
DAW.
See Page 44 for a description of digital input selection.
The FX SEND Busses
Each of the four FX signals can be auditioned on the main monitoring by pressing the
gain pot. There is an LED to the right of the button which lights to indicate that
more on AFLs.)
Stereo Returns
The outputs of the devices connected to the four FX sends would normally be brought back into Matrix using the
2 2 1 81
line-level Stereo Returns, labelled
FX bus master controls.
The top three buttons allow you to route the signal to the MIX,
right of each button lights to indicate the presence of this routing.
The signal can be summed to mono by pressing the
to the right of the button lights to indicate that the signal has been reduced to mono.
Below the MONO button is a pot which functions as a balance pot for stereo signals and a pan pot for mono
TR IP
signals, and at the bottom of each
The signal can be auditioned on the main monitors by pressing the
an LED to the right of the button which lights to indicate that
DIM
Mon
Projec
MIX
REC MON SOLO
Digital I/O
LEFT
MIX
ST RET 1 to ST RET
iJack
Misc
ST RET area there is a gain trim. Both of these pots have Total Recall LEDs.
DIM
CUT
i
n
Me e t rs
t 2 :: T
REC MON
Digital I/O area of the centre section, located immediately below the
area, labelled ADC LOCK, lights to indicate that the desk is locked to the
bus, REC bus, or from the monitor signal (pre-monitor level). The
RIGHT
4. These are located below the REC,
iJack
REC
and
iJack
MONO button below the three routing buttons. An LED
AFL button below the gain pot. There is
AFL is on. (See Page 38 for more on AFLs.)
CUT
i
n
62 2 2
Mon Me e t rs
Projec t 2 :: T
Auto TR
itle
Chapter 3 - Analogue Signal Flow
SOLO
RIGHT
Solid State Logic Matrix
AFL button below the
AFL is on. (See Page 38 for
CUE ST
iJack
CUE ST
busses. An LED to the
62 2 2
1 81
Auto
itle
IP Misc
Matrix 2 Owner's Manual
Solid State
SOURCE
and
1 81
TR IP
37
Misc