Inserting Preset Chains; Removing Assigned Devices - Solid State Logic Matrix 2 Owner's Manual

Chapter 3 - Analogue Signal Flow

Inserting Preset Chains

Any CHAINS of devices you have previously saved can be inserted using the
for creating preset chains).
To insert a preset CHAIN, first ensure you have pressed the
change to show the names of any Preset Chains you have stored on the top row, with additional << and
The button directly above the name Preset Chain will light yellow if available or will be unlit if already in use.
Like with Devices, use the upper
Chain name. The bottom row of the main scribble strip will now display the name of the Chain below the channel name.
If you have a channel that has 2 or more devices on it but you have not saved it as a Preset Chain, the bottom row of the
main LCD scribble strip will display the name of the first device in the first slot.
At the same time, the bottom row of the right-hand LCD scribble strip will display which devices you have in that particular chain
(providing that channel is still selected).

Removing Assigned Devices

When in either DEVICES
can see which channel it is already in use on by simply pressing it. The device label will change to display the channel number e.g.
"Chan 10" and the MODE
To remove the device simply press and hold the desired device button until it re-lights yellow. It is now available to insert using
the normal method.
Matrix 2 Owner's Manual
42
SEL key to selected the desired channel and then press the button directly above the desired
or CHAINS mode, if a device/chain you want to use is already in use, the button does not light. You
display will change to indicate the slot it is currently inserted on.
CHAINS
CHAIN button. The LCD on the right-hand side of Matrix will now
button (see "Chapter 4 - Matrix Remote"
>> keys.