Table of Contents
Advertisement
Chapter 6 – DAW and CC Configuration
In this chapter, we will examine how the standard DAW Profiles covered in Chapters 1 and 5 can be customised, focussing on the
configuration of the four DAW control layers and associated soft keys. We will also cover the configuration of CC (Continuos
Controller) layers for the control of MIDI devices. Layers and soft key assignments for both DAW and CC layers are stored on
the SD memory card in the rear of the console, and are configured in the
Note that the programming described in this chapter is part of the global configuration of Matrix and is therefore
not stored within specific Titles.
Note also that instructions for the initial configuration of your DAW layers can be found in Chapter 1.
Matrix Console Layer Selection
The layers are defined and configured in the Matrix Remote's
described below. However, selecting a layer in the Remote does not select that
layer on Matrix console. The layer which is being controlled from the Matrix
console can then be selected using the
in the Matrix centre section, below the digital scribble strip (shown right). The selected button lights to indicate that it is active.
Layer 1 is active when none of the buttons is lit. If you wish to use Layer 1 and another layer is selected, press the lit button to
return to Layer 1.
Matrix Remote Layer Selection
15
16
The layer being configured in Matrix Remote is selected via the
radio buttons, located in the middle of the tab towards to top. All other functions
in this tab, with the exception of the
the selected layer.
10
5
0
5
10
DAW LAYER SELECT
MASTER/FOCUS
Transport Master
10
0
5
5
0
10
5
15
10
20
Chapter 6 - DAW and CC Configuration
DAW
DIM
CUT
i
n
Mon
Projec
DAW
tab, as
buttons, located
DAW
tab's
Layer
selection, are specific to
10
5
0
5
10
iJack
iJack
tab in the Matrix Remote:
62
Me e
t rs
Auto
t 2 :: T
itle
Matrix
2
Owner's Manual
2 2
1
TR
IP
95
- Quick Links:
- Audio Connections
Hide quick links:
Advertisement
Table of Contents
