Solid State Logic Matrix 2 Owner's Manual page 114

Chapter 6 - DAW and CC Configuration
Foot Switch Commands
The Foot Switches buttons in the middle of the
can be connected to the Matrix to have any USB or listed DAW command assigned to them. Both the HUI and MCU protocols
contain dedicated codes for use with foot switches which actuate the DAW transport Play and Record functions. These are
shown in the command list as
In addition, there is an extra SSL command which has been created specifically for use with the foot switch:
Switch enables the talkback function of the
Note that the foot switch must be held down to keep talkback open.
KVM Hot Key
The KVM Hot Key, located towards the top left of the
The button is only used on setups where there is more than one computer connected to Matrix. The
programmed with a command to a USB KVM switch, telling it to switch between computer ports. When programmed, it outputs
a USB command whenever its layer is selected using the console's
select the USB port connecting to the computer on which the layer's DAW or MIDI device is hosted. The specific commands
used by your KVM switch should be found in its operating manual.
Matrix 2 Owner's Manual
106
Transport/Utility
Play Foot Switch and Record Foot
Artist button to be assigned to a foot switch.
window allow the two momentary foot switches which
Switch.
Transport/Utility window, does not appear on the Matrix console.
DAW LAYER SELECT
Artist Talkback
KVM Hot Key
buttons, telling the KVM switch to
can be