Optiview H.264 DVR System User Manual page 60

Follow the same procedure if more UTP Cameras to CH2, CH3, or CH4 will be installed.
NOTE: Do NOT insert both BNC and UTP video sources to the same
channel simultaneously, or the video will not function correctly and it may cause
the video to look like the figure below. For instance, if a UTP Camera is already
installed to channel 1, do not install another camera to the BNC port of channel 1.
Step 3:
Plug in the power adapter to the DVR, and the DVR will start to boot. The installation is
complete.
NOTE: The UTP Board provides power up to 5.5W. If the power consumption of
the camera is more than 5.5W, the UTP Board will start beeping.
NOTE: The length of each UTP cable should NOT exceed 300 meters (or 984 feet), or
it may cause loss or weakening of signal. The following table shows performance at
different distances.
Distance
Meters / Feet
0
100 / 328
200 / 656
300 / 984
Video Source Selection
Bad Video Output
UTP-Converter
Video Quality
Power Output (W)
5.526 Excellent
5.256 Excellent
5.04
4.77
DVR User's Manual
Good
Good
59