To Export Event Video; Dome Control - Optiview H.264 DVR System User Manual

DVR User's Manual
Press ENTER to start the export; or, press ESC to abort.
If there is no any exportable device connected to the DVR unit, then a
warning message will be shown on the screen, as below figure:
4.4.3

To Export Event Video

To export event video, follow these steps:
Press SEARCH and play wanted event video. To play event video, refer to
Section Searching Recorded Video.
After entering the playback mode, press COPY. The "ezBurn" window will
display as below figure. The information shown is "read only".
Data
2008/06/07
If there is no any exportable device connected to the DVR unit, a warning
message will be shown on the screen
Press ENTER to start the export the whole event video to the connected
device; or, press ESC to abort.
4.5

Dome Control

The DVR allows users to control a dome camera by the front panel.
In Live mode, users can press CHANNEL key to display the desired dome
camera in full screen. To enter Dome Control mode, press the DOME key and
press channel key 2 to display the hint screen. To exit the Dome Control
mode and return to live mode, press ESC or DOME.
To configure the dome controls settings, see the following sections.
36
No exportable device detected.
Please install the target device/media
to the DVR.
Enter: Retry ESC: Exit
ezBurn confirmation
Selected Device: Built-in-DVD+RW
All data on the disc will be erased.
Exported Required Size = 11 MB
Export Event Info:
Time
AM10:42:35
Enter: YES ESC: NO
Ch Type
13 Motion