Fitting The Engine - Husqvarna Rider ProFlex 18 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
12. Use the 506 66 00 48-01 puller if
necessary.
13. Remove the engine fixtures, two on each
side of the engine, and remove the
engine from the rider.
The picture shows the right-hand side
without the hydraulic cylinder fixture
(ProFlex 18). For the left-hand side,
see the illustration under 'Fitting'

Fitting the Engine

IMPORTANT INFORMATION
When fitting the engine, it is important
that the belt pulley's groove (1) is in such a
position that the outgoing shaft's key (2)
fits into the groove (see illustration). Also
check that both the spacing tube (3) and
key (2) are well fitted to the engine shaft.
Grease the engine shaft.
1. Lower the engine into place and tighten
the engine fixtures (two on each side of
the engine) with a torque of 25 Nm/18 lbf.
ft.
The battery's negative cable should be
attached to the forward left screw. The
hydraulic cylinder fixture should be
attached to the forward right screw on
the ProFlex 21.
REPAIR INSTRUCTIONS
www.mymowerparts.com
Engine belt pulley remover
The engine's fastening screws, right side. Mount not
shown
Engine shaft and belt pulley
Engine mount screws and negative cable
8009-518
8009-192
6019-039
8009-365
29
English-