Selecting Microsoft As Your Security Choice - Intermec CN50 User Manual

Chapter 2 — Connecting and Configuring the CN50
46
AES if you choose WPA2, and WEP if you choose Open or
Network EAP.
8 For Prompt for Credentials, choose Enter credentials now.
9 Enter a User Name and User Password.
10 Save your settings.
Configuring Static WEP Security With Funk Security
Use the following procedure to configure static WEP security with
Funk.
1 Make sure the communications and radio parameters on your
CN50 are configured.
2 Make sure Funk is selected as your security choice.
3 Start Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security.
5 Select the profile you want to configure.
6 For Association, choose Open.
7 For Encryption, choose WEP.
8 For 8021x choose None.
9 Define a value for the keys you want to use. You can define up to
four keys (Key 1 through Key 4).
Enter an ASCII key or a hex key that is either 5 bytes or 13 bytes
long depending on the capability of the radio. Set a 5- byte value for
64-bit WEP or a 13-byte value for 128-bit WEP. Hex keys must be
preceded by 0x and contain 5 or 13 hex pairs.
10 For Transmit key, choose the key you want to use for transmitting
data.
11 Save your settings.

Selecting Microsoft as Your Security Choice

The default security setting is Funk. If you want to use Microsoft
security, you need to select it as your security choice. After you select
Microsoft as your security choice, you will be prompted to save your
settings and reset your CN50 for your change to take effect.
CN50 Mobile Computer for Windows Mobile 6.1 User's Manual