Intermec CN50 User Manual page 58

Chapter 2 — Connecting and Configuring the CN50
44
Configuring WPA or WPA2 with Funk Security
Use the following procedure to configure WPA or WPA2 with Funk
security.
1 Make sure the communications and radio parameters on your
CN50 are configured.
2 Make sure Funk is selected as your security choice.
3 Start Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security.
5 Select the profile you want to configure.
6 For Association, choose WPA or WPA2.
7 For 8021x, choose None.
8 For Pre-Shared Key, enter the pre-shared key or passphrase.
The pre-shared key must be a value of 32 hex pairs preceded by 0x
for a total of 66 characters. The value must match the key value on
the access point. The passphrase must be from 8 to 63 characters.
After you enter a passphrase, the CN50 internally converts it to a
pre-shared key. This value must match the passphrase on the
authenticator.
9 Save your settings.
Configuring 802.1x Security With Funk Security
Use the following procedure to configure 802.1x security with Funk
security.
1 Make sure the communications and radio parameters on your
CN50 are configured.
2 Make sure Funk is selected as your security choice.
3 Start Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security.
5 Select the profile you want to configure.
6 For Association, choose Open.
7 For Encryption, choose WEP.
CN50 Mobile Computer for Windows Mobile 6.1 User's Manual